Proudly Accepts:   
  

Member Login   |   Membership Registration   |   View Cart   

ATS (SG) PRIVATE LIMITED
GST Reg. No.: 201510854D
 

We ship by  

Home About Us Contact Us Privacy Policy Terms
CURRENCY



PRODUCTS
::DYNAMIC INK
::ETERNAL INK
::FUSION INK
::INTENZE INK
::KURO SUMI INK
::SILVERBACK INK
::STARBRITE INK
::WORLD FAMOUS TATTOO INK
::BISHOP ROTARY TATTOO MACHINE
::CHEYENNE (HAWK ROTARY MACHINE)
::CRITICAL TATTOO
::DARKTIMES TATTOO MACHINES
::DIVINE MACHINE
::EIKON TATTOO EQUIPMENT
::FALLEN KING IRONS (FK Irons)
::INKJECTA
::INK MACHINE
::LACEnano ROTARY TATTOO MACHINE
::MICKY SHARPZ
::SUNSKIN TATTOO MACHINE
::WORKHORSE IRONS
::KWADRON
::MITHRA
::TATTOO PREMADE NEEDLES
::TATTOO PREMADE CARTRIDGES
::TATTOO TRANSFER PAPER & PRINTER
::TATTOO ACCESSORIES
::TATTOO CARE
::MORPHIX
::DISPOSABLE TIPS & TUBES
::STAINLESS STEEL TIPS & GRIPS & TUBES
::T-SHIRTS

BEST SELLERS BY BRAND
::Tattoo Goo
::Hustle Butter





Online Catalog

INK MACHINE > Spare Parts and Tools :: Inkmac Excenter Assembly No. 41

Inkmac Excenter Assembly No. 41
     
Options :
Quantity :

* Price exclusive of GST. Singapore customers will be charged GST upon checkout.


  • Fits all Dragonfly machines. Pre-set to Short Stroke 2.6mm 
  • Fits all Dragonfly machines. Pre-set to Standard Stroke 3.7mm

Can also be adjusted with the Precision Tool Kit (No. 90) from 2.6 - 4.5mm

Note that you will also need the Circlip Pliers (No. 55) to replace this assembly. Use the Circlip Pliers to remove the Circlip and push out the Connecting pin. Loosen the excenter from the motor shaft with the smallest allen key 0.9mm. There are two screws on the standard excenter, one for the motor shaft and one for the bearing shaft. You only need to use the one for the motor shaft. Install the new assembly on the motor shaft and make sure that the screw ends up on the flat part of the shaft and tighten it securely. Check that the Connecting rod aligns properly with the groove in the Piston. This is important, if it does not align correctly it will not run properly and you might have to readjust the location of the motor. In that case please refer to the manual or send for service. If ok align the upper bearing with the hole in the piston and insert the Connecting pin and install the Circlip.



© Copyright 2013 Asia Tattoo Supply. All rights reserved.
| Terms & Conditions  | Privacy Policy |